最新的Avaya-Certification認證 6101-1考試題庫

問題1

A technician is adding the Virtual Link Aggregation Control Protocol (VLACP) configuration ID a Converged Campus Solution where all Ethernet Routing switches (ERSs) are directly connected without intermediary WAN transport devices
What are two key configuration tasks? (Choose two)

A. configure all links to use the default multicast MAC address for VLACP messages

B. For the 1ST links, configure the long timeout value

C. For the SMLT links, configure the long timeout value

D. Configure all links to use a unique reserved multicast MAC address for VLACP messages

正確答案: B,D

問題2

A technician has implemented RSMLT edge design. After recovering from a power outage some clients could not communicate. It has been determined that only one of the core RSMLT switches has recovered.
What should have been done to prevent the loss of communications?

A. Increase the Holdup timer to 9999

B. Turn on the HoIdDown timer

C. Set the VLAN to copy RSMLT into from a similarity configured VLAN.

D. Clear the peer IP and MAC addresses

正確答案: D

問題3

Which VLAN/VLANs should be tagged on the IST for a proper functioning SMLT configuration?

A. Only the VLANs that are also tagged on the SMLT/SLT uplinks

B. the IST VLAN and ail the VLANs that are tagged on all SMLT/SLT links

C. Only VLAN 1 and the IST

D. Only VLAN 101

正確答案: B

問題4

A split multi link trunking (SMLT) for switch clustering is being configured.
Which statement is a configuration requirement for the SMLT?

A. CP-limit is configured on edge switch stacks

B. Neighboring edge switch stacks should be connected to each other via DMLT connection to add resilient paths in the event of an SMLT failure

C. VLANs that are defied on the SMLT are also defined on the MLT that defines the core IST

D. Alternate the primary path of the SMLT connection to load balance the switch core

正確答案: C

問題5

A switch with Simple Loop Prevention Protocol (SLPP) did not detect a loop.
What are two reasons this occurred? (Choose two)

A. the VLAN where the loop originated to the SLPP transmitting list was not added.

B. Extended CP limit on the transmitting port was not configured.

C. A premier License for SLPP is needed.

D. SLPP was not globally enabled

正確答案: A,D

問題6

Consider the fallowing port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module left LED -green Right LED - flashing green
What is the status of the port?

A. The link speed is 1000 Mbps. and the port is passing traffic.

B. The link speed is 100 Mbps. and the port is passing traffic.

C. The link speed is 1000 Mbps, and the port is disabled

D. The link speed is 100 Mbps. and the port is disabled.

正確答案: B

問題7

A technician is configuring an Ethernet Routing Switch (ERS) 5520-24T for the edge of the Converged Campus network. in band communication to edge switch is a customer design requirement.
Which two VLANS are acceptable VLANs to use for the switch/stack IP addresses? (Choose two)

A. management

B. voice

C. default

D. data

正確答案: A,D

說明：（僅 VCESoft 成員可見）

最新的Avaya Ethernet Routing Switch Implementation - 6101-1免費考試真題

最新更新

站內鏈接

聯系我們