最新的Avaya Specialist認證 6101.1考試題庫

問題1

Auto-negotiation should be enabled on all ports except under which condition?

A. when only the core switches support Auto-negotiation

B. when there is a mix of R and RS modules in the stack

C. when there is fiber ports in some end workstations

D. when there is a mix of 10 Mbps and 1 Gbps end servers

正確答案: A

問題2

When configuring Ethernet Routing Switch (ERS) 8600 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI.
How is the ACLI interface obtained?

A. Change the interface type in the config.cfg file.

B. Change the ACLI boot flag and save the boot configuration file.

C. Use the abort command and enter "no" at the default interface prompt

D. exits the CLI and chooses ACLI at the interface manager prompt.

正確答案: D

問題3

A network has some Ethernet Routing Switch (ERS) 5500 switches licensed at the advanced level for Release 6 2 A technician implementing Protocol independent Multicast
-
Sparse Mode (PIM-SM) Which licensing requirement applies?

A. the PIM-SM con only be licensed on ERS 5510 models

B. the PIM-SM is included m the base license with release 6.2

C. the PIM-SM is already covered by the existing advanced feature license

D. A Premier license is needed

正確答案: B

問題4

Which statement describes how to configure Simple Loop Prevention protocol (SLPP) Rx?

A. SLPP is configured on the Inter Switch Trunk (1ST) ports of the core switch cluster.

B. SLPP is configured on the uplink ports of both the core switch cluster and the edge switch

C. SLPP is configured on the edge switch ports that connect to the core switch cluster.

D. SLPP is configured on the core switch cluster ports that connect to the edge switch.

正確答案: B

問題5

A switch with Simple Loop Prevention Protocol (SLPP) did not detect a loop.
What are two reasons this occurred? (Choose two)

A. the VLAN where the loop originated to the SLPP transmitting list was not added.

B. Extended CP limit on the transmitting port was not configured.

C. A premier License for SLPP is needed.

D. SLPP was not globally enabled

正確答案: A,D

問題6

A customer has purchased some Ethernet Routing Switch (ERS) 5600 switches must integrate two ERS 5600 units into existing stack of ERS 5500 switches.
What is the procedure for the integration of the new ERS 5600?

A. With power applied to the stack, integrate one ERS into the stack as non base unit in mixed stack operational mode. Change the existing ERS 5500 base unit to "non base unit" and set the new 5600 to "base unit". Reboot the stack integrate the second ERS 5600 in mixed stack operational mode.

B. With power applied to the stack, integrate one ERS into the stack as non base unit in mixed stack operational mode. After the two ERS 5600 units have obtained their configuration from the ERS 5500 base unit, change the ERS 5500 to "non base unit" and set one ERS 5600 to "base unit". Reboot the switch stack.

C. with power applied to the slack, change the existing ERS 5500 base unit to "Non Base Unit" in mixed stack operation Integrate the two new ERS 5600 to the stack with them set as "Base Unit" in mixed stack operation Reboot the stack.

D. Remove the AC from the stack, integrate the two ERS 5600 units into the existing 5600 set to "base unit" and one ERS 5600 set to "non base unit" set the existing ERS 5500 base unit to "non base unit" apply power to stack.

正確答案: B

問題7

A technician is configuring password levels on the Ethernet Routing Switch (ERS) 8600, and wants the manager to be able to view and edit most device settings, but not be able to change security and password settings.
Which login Level should be set for the manager?

A. Read-Write Access

B. Read Write All Access

C. Layer3Read-WnteAccess

D. Layer 2 Read Write Access

正確答案: A

最新的Avaya Ethernet Routing Switch Implementation - 6101.1免費考試真題

最新更新

站內鏈接

聯系我們