最新的H3CSE-RS-SW - GB0-372-ENU免費考試真題

A. After receiving the low-priority configuration BPDU, SWC will immediately respond with the configuration BPDU with itself as the root.

B. After the priority is adjusted, SWA will still send configuration BPDUs with itself as the root.

C. After the configuration BPDU saved locally by SWB ages, it will send a configuration BPDU with itself as the root to SWA.

D. By default, the topology will converge again after 30 seconds.

A. The automatically generated RD value is "N:VXLANID", where N is an integer starting from 1. If there is a duplicate RD, N+1 is added until an unused RD is found.

B. The automatically generated RT value is "BGP AS: VXLANID"

C. The automatically generated RD value is "BGP AS: VXLANID"

D. The automatically generated RT value is "BGP AS: VXLAN ID + N, where N is an integer starting from
1. If there is a duplicate RD, then N + 1 is added until an unused RD is found.

A. No default domain is specified on the RADIUS Client

B. The network cable between RADlUSServer and RAD olds Client is not connected

C. The message shared key between RADIUS Server and RADIUS Client is not the same

D. The username is not configured on the RADIUS server.

A. Intra-domain multicast routing protocols include: MSDP, DVMRP, MOSPF, PIM

B. In sparse mode, multicast data streams are sent from the multicast source to the multicast receivers in a pull manner, and the multicast receivers actively send reception requests.

C. Multicast routing protocols have two modes: dense and sparse

D. In dense mode, multicast data streams are pushed from the multicast source to every corner of the network, and multicast receivers passively receive multicast packets.

A. There can only be one RP in a PIMSM domain.

B. There can only be one BSR in a PIMSM domain.

C. There can be only one C-RP in a PIMSM domain.

D. There can be only one C-BSR in a PIMSM domain

A. To facilitate network management, you can configure an IP management address on VLAN 4092.

B. The primary ring control VLAN on switches SWB and SWC can be different from that on SWA.

C. The ports on switches SWA, SWB, and SWCRRPP rings that access the RRPP ring need to be added to VLAN 4092

D. All ports on switches SWA, SWB, and SWC need to be added to VLAN 4092

A. RT1

B. RT4

C. RT3

D. RT2

A. When there are no receivers of multicast group G locally in the DR, the DR will send a prune message to the upstream router.

B. If there is still a receiver in the shared network segment under the interface where the upstream router receives the prune message, the receiver will send a group join message

C. As long as the DR has a receiver of multicast group G locally, the DR will periodically send a join message to the upstream.

D. Both PIMSM and PIM DM have pruning veto processes