最新的Juniper Data Center, Associate (JNCIA-DC) - JN0-281免費考試真題

A. To connect an OSPF area to the backbone area through a non-backbone area.

B. To connect OSPF areas to external networks.

C. To encrypt OSPF traffic.

D. To balance load across multiple links.

A. By ensuring the same IP address range can be used in different VLANs.

B. By encrypting data traffic between VLANs.

C. By enabling the identification and separation of traffic belonging to different VLANs.

D. By providing a backup path for data in case of link failure.

A. Aggregation layer

B. Access layer

C. Modular layer

D. Function layer

E. Core layer

A. Activation of all ports for Virtual Chassis connections

B. Incompatible software versions between member switches

C. Use of copper cables for inter-switch connections

D. Too many switches in a single Virtual Chassis configuration

A. AS path

B. local preference

C. multihop

D. multipath

A. There is a maximum of five hops between any end-devices

B. There is a maximum of three hops between any end-devices

C. They are commonly referred to as interconnected data centers

D. They are typically deployed in small to medium data centers

A. Stub Area

B. Default-Free Zone

C. Virtual Link Area

D. Not-So-Stubby Area (NSSA)

A. Other routes are selected because of better metrics.

B. There are too many hops to the destination.

C. The BGP next hop is unreachable.

D. Load balancing is not enabled.

A. The port is disabled.

B. It causes Layer 2 loops.

C. No logging takes place.

D. It drops the packet.

A. No traffic is traversing the LAG interfaces.

B. The LAG interfaces are in aggressive mode.

C. The LAG interfaces are in a passive state.

D. No operational interfaces have been added to the LAG interfaces.

A. It finds the path with the numerically lowest route preference.

B. It finds the path with the shortest autonomous system path.

C. It finds the path with the numerically lowest cost.

D. It finds the path with the least number of hops.