最新的Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP) - JN0-363免費考試真題

A. Type 3

B. Type 5

C. Type 7

D. Type 1

A. The Junos OS will use the IP address assigned to the loopback interface for the router ID.

B. A router ID will not be assigned until it is manually configured.

C. The Junos OS will use the IP address assigned to the interface with the lowest MAC address.

D. The Junos OS will use the IP address assigned to the Interface with the highest priority.

A. Type 3

B. Type 5

C. Type 7

D. Type 1

A. 10.1.1.1

B. 11

C. 12

D. 10.1.1.2

A. Issue the sec protocols ospf area 0.0.0.0 interface ge-0/0/1.0 command.

B. Under the [edit routing-options] hierarchy, configure a 128-bit router ID.

C. issue the set protocols ospf3 area 0.0.0.0 interface ge-0/0/1.0 command.

D. Under the [edit routing-options] hierarchy, configure a 32-bit router ID.

A. The untagged frames are load balanced between VLAN 10 and VLAN 20.

B. The untagged frames are associated with VLAN 10.

C. The untagged frames are associated with VLAN 20.

D. The untagged frames are dropped.

A. LDP label-switched paths are created by configuring LDP on the loopbacK Interface.

B. The inet.3 table will contain a full mesh of label-switched paths to other LDP-enabled routers.

C. LDP label-switched paths are created by configuring LDP on at least one physical router interface.

D. The lnet.3 table will contain only the paths explicitly defined.

A. user@router1> ping 10.0.0.2 routing-instance vr3 count 5

B. user9router1> ping 10.0.0.2 count 5

C. user@vr3> ping 10.0.0.2 count 5 source 10.10.10.1

D. user@vr3> ping 10.0.0.2 count 5

A. You can use it to resolve the next hop if the next hop is not directly connected.

B. You can use it to send unwanted traffic to a null route.

C. You can use it to install the static route into different routing tables.

D. You can use it to specify multiple next hops with different preferences.