最新的 NCS Professional NCS-Core 免費考試真題:

1. A customer has an ESXi cluster with two 10GbE NICs on each node and the following requirements.
#Solution must follow Nutanix Best Practices
#Network configuration should be redundant
#A vSphere Distributed Switch will be utilized
Which load balancing configuration should be used?

A) Route based on originating port ID
B) Route based on physical NIC load
C) Route based on IP hash
D) Route based on source MAC hash

2. In preparing to install a new cluster for a company, a consultant needs to complete an installation worksheet.
Which values must be documented prior to initial base system setup?

A) Block Serial Numbers
B) DNS and NTP IP Addresses
C) Prism Central IP Address
D) Hypervisor, CVM, and IPMI IP Addresses

3. An administrator wants to utilize Network Visualization to monitor the physical and logical network on the Nutanix cluster. The first-hop switch has LLDP enabled. The network switch information is still not being displayed.
What is causing this problem?

A) SNMP is not configured properly.
B) The cluster is using RDMA-enabled NICs.
C) br0 and br1 are not defined.
D) The ISL between switches is not configured.

4. A consultant has deployed a new Nutanix AHV cluster with Foundation. The customer requests separating the management and production traffic in the CVM.
Which feature should the consultant configure?

A) VLAN Tagging
B) Micro-segmentation
C) Multi-homing
D) Network Segmentation

5. A consultant configures a Nutanix cluster and integrates the hosts into vCenter using VMware best practices.
The customer has requested that the Nutanix cluster only have a single datastore.
Upon configuring the cluster per the customer requirements, vCenter displays an alert regarding the heartbeat datastore. The consultant adds the das.ignoreInsufficientHbDatastore value = true rule. The container can be seen from each host, but the alert remains active.
What should the consultant do to resolve this issue?

A) Turn off and then turn back on HA.
B) Create a second container.
C) Make sure the DRS setting is turned on.
D) Whitelist the vCenter IP address within Prism.

問題與答案：