最新的 Cisco and NetApp FlexPod NS0-176 免費考試真題:

1. You installed a new NetApp cluster running clustered Data ONTAP. There is a single Storage Virtual Machine (SVM) named esx1 on the cluster.
A volume named esx_datastore1 is created in the SVM esx1. The name of the root volume for the esx1 SVM is esx1_rootvol. The default export policy was applied to the volume esx1_rootvol.
You verified that the export policy applied to esx_datastore1 contains a single rule that allows all clients to mount the volume as read/write using any version of NFS. A Linux client attempts to NFS mount the volume and receives a Permission Denied error.
In this scenario, what caused this error?

A) The volume esx_datastore1 has not been mounted into the namespace of the esx1 SVM.
B) NFS has not been configured on the SVM esx1.
C) UNIX permissions for the volume esx1_rootvol are not set to read/write.
D) The default export-policy does not have at least one rule to allow all clients read-only access.

2. Exhibit:

Which hardware component is shown in the exhibit?

A) VIC
B) GEM
C) IOM
D) Fl

3. Given the following switch output, where would you expect see notification level messages?
N5K-1# show logging info.
Logging console: enabled (Severity: error)
Logging monitor: enabled (Severity: informational)
Logging linecard: enabled (Severity: emergency)
Logging fex: enabled (Severity: notifications)
Logging time stamp: seconds
Logging server: disabled
Logging logfile: enabled

A) On the terminal sessions
B) On the linecard
C) Notification messages will not be seen anywhere
D) On the console

4. Refer to the exhibit.

When configuring a Cisco UCS B-Series server to support boot from SAN in a FlexPod deployment, which statement is correct?

A) This configuration will support boot from SAN
B) This configuration will not support boot from SAN.
C) This given configuration will not support a local ESXi installation
D) Boot from SAN is not supported in a FlexPod environment

5. An administrator just finished installing Windows Server 2012 (Core) with Hyper-V.
Now the administrator must deploy a new VM using PowerShell with the parameters shown below.
--Name: web server
--Memory: 10 GB
--Hard Drive: Existing Disk (d:\vhd\BaseImage.vhdx)
Which PowerShell command creates the VM based on the Information in the scenario?

A) New-VM-Name "web server"- MemoryStartupbytes 10 GB - VHDPath d:\vhd\BaseImage.vhdx -NewVHDSireBytes 6000000
B) new- VM- Name web server- MemoryStartupBytes 10GB- VHDPath BaseImage.vhdx
C) New-VM-Name web server-MemoryStartupbytes 1 GB- VHDPath BaseImage.vhdx
D) New-VM-Name "web server" - MemoryStartupbytes 10 GB- VHDPath d:\vhd\BaseImage.vhdx

問題與答案：