最新的 Nutanix Certified Master NCM-MCI5.15 免費考試真題:

1. An administrator is using Nutanix Move to migrate a Windows VM from ESXi to AHV. Automated guest preparation is failing with an error:
Account has UAC enabled error
The administrator is using the local built-in administrator account for the Windows VM Admin approval mode must remain enabled.
What should the administrator do to continue with the migration with Nutanix Move?

A) Use a Domain Admin account for the Windows VM
B) Place Windows VM in Maintenance Mode
C) Reboot the Windows VM and try the migration again
D) Follow manual VM preparation guidelines

2. A customer has a Nutanix cluster with 10Gb connectivity via switch fabric extenders. The administrator receives NCC health check errors of latency greater than 200ms.
Which action should the administrator take to resolve the NCC errors?

A) Add 2 additional 10G uplinks from the switch fabric extenders per node
B) Replace the switch fabric extenders with 10G line rate switches
C) Upgrade NCC and increase the vCPU of the CVM
D) Upgrade NCC and increase the CVM memory by 4Gb

3. A customer with a four-node RF2 cluster is adding application VMs to their system. After adding these VMs, the Prism dashboard shows 81% storage utilization.
What is the consequence of running the cluster at 81% storage utilization?

A) There is available capacity in the storage fabric and the cluster is resilient.
B) Node failure is imminent due to storage utilization.
C) The customer has the ability to add more VMs up to the 100% storage utilization.
D) The cluster is not resilient in the storage fabric

4. An administrator receives an error indicating that the CVMs in the cluster are not syncing to any NTP servers. An investigation of the issue finds:
* The NTP servers are configured in Prism
* The time on all CVMs is the same
* Both the CVMs and AHV hosts are configured for the UTC time zone
Which two steps can be taken to troubleshoot this issue? (Choose two.)

A) Confirm that the NTP servers are reachable from the CVMs.
B) Restart genesis on all CVMs.
C) Restart the chronos service on all CVMs.
D) On a CVM. run the command a Hash ntpq -pn.

5. An administrator wants to utilize Network Visualization to monitor the physical and logical network on the Nutanix cluster. The first-hop switch has LLDP enabled. The network switch information is still not being displayed.
What is causing this problem?

A) SNMP is not configured properly.
B) The cluster is using RDMA-enabled NICs.
C) br0 and br1 are not defined.
D) The ISL between switches is not configured.

問題與答案：